Характеристики и описание
Описание оборудования | |
|---|---|
| DeviceNet Gateway, double master for 2AS-Interface networks | |
General specifications | |
| AS-Interface specification | V3.0 |
| PLC-Functionality | activateable |
| Duplicate address detection | from AS-Interface slaves |
| Earth fault detection | integrated |
| EMC monitoring | integrated |
| Diagnostics function | Extended function via display |
| UL File Number | E223772 only from low voltage, limited energy source (SELV or PELV) or listed Class 2 source |
Indicators/operating means | |
| Display | Illuminated graphical LC display for addressing and error messages |
| LED AS-i ACTIVE | AS-Interface operation normal; LED green |
| LED CONFIG ERR | configuration error; LED red |
| LED PRG ENABLE | autom. programming; LED green |
| LED POWER | voltage ON; LED green |
| LED PRJ MODE | projecting mode active; LED yellow |
| LED U AS-i | AS-Interface voltage; LED green |
| LED MNS | Module/net status; LED green/red |
| Switch SET | Selection and setting of a slave address |
| OK button | Mode selection traditional-graphical/confirmation |
| Button MODE | Mode selection PRJ-operation/save configuration/cursor |
| ESC button | Mode selection traditional-graphical/cancel |
Electrical specifications | |
| Insulation voltage | ? 500 V |
| Rated operating voltage | from AS-Interface |
| Rated operating current | ? 200mA from AS-Interface circuit 1 ? 70 mA from AS-Interface circuit 2 |
Interface 1 | |
| Protocol | DeviceNet |
Interface 2 | |
| Interface type | RS 232, serial Diagnostic Interface |
| Transfer rate | 19,2 kBit/s |
Connection | |
| AS-Interface | spring terminals, removable |
| DeviceNet | 5-pin CombiCon connector according to DeviceNet specification |
Directive conformity | |
| Electromagnetic compatibility | |
Standard conformity | |
| Electromagnetic compatibility | EN61000-6-2:2005, EN61000-6-4:2001, EN50295:1999 |
| Degree of protection | EN60529:2000 |
| AS-Interface | EN62026-2:2013 |
Approvals and certificates | |
| EAC conformity | TRCU 020/2011 |
| UL approval | An isolated source with a secondary open circuit voltage of ? 30VDC with a 3A maximum over current protection. Over current protection is not required when a Class 2 source is employed. UL mark does not provide UL certification for any functional safety rating or aspects of the device. |
Ambient conditions | |
| Ambient temperature | 0 ... 55 °C (32 ... 131 °F) |
| Storage temperature | -25 ... 85 °C (-13 ... 185 °F) |
Mechanical specifications | |
| Degree of protection | IP20 |
| Mass | 520 g |
| Construction type | Low profile housing , Stainless steel |
Описание оборудования
По вопросу интересующей Вас продукции, пожалуйста, свяжитесь с
Доставка
Оплата и гарантии